CyberPower PowerPanel Manual de usuario descargar pdf (Pagina 6)

PowerPanel Shutdown Service

Step 2. Configure Trap Notification and Event Action on CyberPower Network

Management System.

(The Installation of CyberPower Network Management Card please refer to Appendix 1)

1. Open the Web Browser and enter the IP address of CyberPower Network Management

System. (The procedures to establish the IP address please refer to Appendix 2.)

2. Type the username and the password on the login screen to enter the configuration page.

By default, the username is “cyber” and the password is “cyber”.

3. Click on Trap Notification page, selected from Network menu.

4. Enter the IP address of the server or workstation that protected by PowerPanel Shutdown

Service. Please note only two servers or workstations are allowed.

5. Setup the Community of Trap Notification, maximum of 15 characters and then click Apply

to activate the settings. The default value is “public”.

6. Enter Event Action page, selected from Events menu.

7. Ensure Informational, Warning, and Critical notification are enabled for SNMP Trap.

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Sin comentarios

CyberPower PowerPanel Manual de usuario Pagina 6